THIN REPAIR MORTAR

DESCRIPTION:
Cement base, thin repair mortar for surface.

APPLICATION AREAS:
For the interior & exterior surfaces can be used as a repair mortar and thin plaster.

SPECIFICATION:
For the interior surfaces can be used as a repair mortar and thin plaster. It has high adherence & strength.

SURFACE PREPARATION:
Application surface should be purified from mould oil, paint , dust , low adherence , movable materials etch , Surface should be moistured before application. For very smooth surfaces to increase the surface adherence FIXKIM PRIME COAT should be spread to the surface by using brush and before drying it should be applied.

PREPARED MORTAR AND APPLICATION:
25 kg. of THIN REPAIR MORTAR is added 4-5 lt water and mixed by hand mixer, Rest the mixture 5 min and mix it again till it becomes homogeneous.
For Surface smoothness
Prepared thick repair mortar is spread by using steel trowel. Finishing is made by using steel trowel or sponge . Application thickness is between 3-5 mm . For thicker than 10 mm application , second layer application is recommended . Second layer is spreader after the first layer is fully became dry.

For Repairment:
Clean the plaster on the surface. Make V type section along the crack approximately 10 mm. Full fill the cracks and finish the surface.

NOTIFICATION:
Can not be added anything (Lime, Cement, Gypsum etch. ) to mortar. Expired mortar can not be used. For improvement of the mortar it should be moistured periodically for 7 days. Can not be applied to the frozen surfaces. It should be protected to dry very fast Since it is a cement base material, direct contact of hands should be avoided. Gloves should be worn.

STORAGE:
Under the dry & humidity free circumference in the original cover Can be stocked 8 months with a stacking not exceed 10 tiers. Should be consumed in 7 days after cover is open.

CONSUMPTION :
For 1 mm thickness : 1, 6 kg. /m²

TECHNICAL SPECIFICATION